New Year Service Overdue Bug

[Keato]

I’ve got about 4k miles to go before my next service at the dealer - but the double click trick on the left stalk to clear the error message has stopped working - has anyone else had this problem?

It happens sometimes. Press the OK button on the right side of steering wheel and then try again with the stalk

 

[CrazyOldMan]

It happens sometimes. Press the OK button on the right side of steering wheel and then try again with the stalk

Good suggestion- will try that tomorrow.

 

[Sela_2024]

I’ve got about 4k miles to go before my next service at the dealer - but the double click trick on the left stalk to clear the error message has stopped working - has anyone else had this problem?

Happened to me but it was temporary. Next time I drove it states work no fine.

 

[Cheshire cat]

My reset trick seems to have stopped also. I just ignore it for now.

 

[Tazzieman]

Getting close to the predicted 1000 posts on this thread!

 

[RB60]

It does not work for me.

 

[CrazyOldMan]

It happens sometimes. Press the OK button on the right side of steering wheel and then try again with the stalk

That seemed to work this morning - not sure why, but it did, so muchos gracias!

 

[singlefin]

It happens sometimes. Press the OK button on the right side of steering wheel and then try again with the stalk

This is what I found to work or use one of the CCI buttons like fav to get the cursor out of the range remaining field.

 

[skinny_tom]

Use the center console dial to move the selection off the warning, then try again.

 

[IslandFalconer]

I’ve got about 4k miles to go before my next service at the dealer - but the double click trick on the left stalk to clear the error message has stopped working - has anyone else had this problem?

Never worked for me. I have a 23’ prototype and it just cycles through. Not sure it’s a reliable fix

 

[CrazyOldMan]

Never worked for me. I have a 23’ prototype and it just cycles through. Not sure it’s a reliable fix

Try the OK or center dial - it could be that the left stalk is zeroed in on a different command (not sure how to phrase that). I got it to work (again) this morning with the OK button, after 3 days without being able to get it to work (it was working before that)