The Grenadier Forum

Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please use the contact us link at the bottom of the page.

Front drive shaft broken

The front and rear driveshafts.
Would they have had any input you think in terms of the design and orientation of the TC to axle pitch of the front and rear shaft or does that buck stop with Magna or other? If not, I wonder whether they should have (or did) comment at the sub optimal angle of dangle of the front shaft? Guess will never know.
 
The miles were spread out over many vehicles and they did not do nearly enough high speed driving over long distances which seems hasten the CV boot failure.
Bingo. In the US we drive 80 MPH for hours or days on end. Most failures have involved mileage, and road failures. Mine was towing on a bouncy road.
 
Let me add, I assumed this would be a huge problem off road. After all, you are flexing out a shaft with too little travel. But I have not seen one off road fail. I would encourage someone testing a new rig to be a little more broad in their approach. That is what bites manufacturers so often. They should have had a few testing in America.
 
If long, fast drives (85mph/140km/hr) are a factor, Europe should be seeing failures at an higher rate than places like Australia (110km/.hr limit except in one state : 130km/hr.
Maybe you are only allowed one out of the two <Lifted> and <driven fast>?
 
Dealers deny everything, always. Must be a requirement. IA is well aware as the lead engineer went into a fit of rage when I mentioned it and he kept screaming how Dana screwed them....yes they know they have a disaster.
And I have been having conversations with one of the highest placed IA staff in North America. They know and are trying to get a handle on what the failure rate really is. Likely they are doing the math to figure out how many will go pop during the warranty period.
 
And I have been having conversations with one of the highest placed IA staff in North America. They know and are trying to get a handle on what the failure rate really is. Likely they are doing the math to figure out how many will go pop during the warranty period.
Well, hopefully they get on it soon and not let the animosity keep building on this design flaw.
 
What is it with those deep dish rims with racing slicks? I see them on so many trucks now and it looks ridiculous. Apparently that is the fault of New Zealand culture if I read that right?
 
  • Like
Reactions: CRH
Back
Top Bottom