The Grenadier Forum

Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please use the contact us link at the bottom of the page.

Featured content

Have standing water in the RHS rear footwell. (UK rhd vehicle). A few mill on the mat and also under mat. Also a few spots in the door pocket. Trying to trace source but thought I'd check on here to see if anyone has had similar? Photos to follow.
Thread 'This has fallen off'
Hi. I have just found this in the back of the Grenny, I think it might have fallen off one of the back doors?? I cannot for the life of me find out wher it is from 👍
Thread 'NAS version getting household plug in rear?'
Caught this screengrab from a FB video. It was a test drive from one of the US dealers. Hoping this is standard.
I have ordered a Trialmaster with non-heated seats and plan to install the ‘body’ of a small UHF Radio (with built-in speaker) under the front passenger seat. The bracket for the radio is approximately 4.5 x 3.0 inches (about 11.5 x 7.5 cm). Can anyone give me an idea of what the structure is like under the seat for the purpose of attaching this bracket, or would I be better off to fix it to the seat rails?
Rubbertree is a NZ and Australian business that has been working on interior accessories for the Grenadier for a while. Now available on the website. Canvas and neoprene seat covers Carpet and rubber mats Boot/trunk liners ... Free shipping within Australia. This is not an endorsement. I have no affiliation with Rubbertree and have not seen any of their products. Grenadier products @ Rubbertree
Hello everbody, I want to remove the cupholder between the front seats for installing a self-made tray. I removed the four screws but the cupholder wasn't removable. Are there some clips or is there a trick to remove the cupholder? Thanks a lot for your answers. Greetings, Roland
Thread 'Floor trim to access wiring tray'
Any ideas how to remove this piece under the plastic floor trim. Removal of bolts yields little movement or release in any obvious way. I want to run some wiring inside through to the rear (UHF Antenna cable). Maybe I'm missing something, maybe there's a better way? Any help is appreciated. Cam
Thread 'Transfer case gear lever boot'
I use low range to reverse up my steep driveway almost every day. I’ve just noticed the transfer case leather gear lever boot has abnormal wear where the lever obviously jams the boot up against the surrounds when it’s moved forward. The same does not appear to be occurring on the opposite side. I imagine it’s merely an adjustment problem, but I would be interested to know if others may have the same.
Thread 'Simple solution so that the phone does not slip'
I have not seen that it has been published before, yes, it has been done, I'm sorry, it is a simple and very economical solution, to avoid the phone. go tumbling everywhere, or shoot out from one of the two trays, you can find them for less than €2.
Thread 'Condensate between screen and compass cover'
Had my car parked for two weeks now. Someone also faced condensate between screen and compass cover?
Thread 'Rear Seat Adjustment - moving my 5 Seater Commercial (UK) rear seat to Field/Trialmaster position.'
Disappointed with the legroom in the 5 Seater Commercial (UK) Grenadier. No problem, simply move the rear seat to match the location of the Trial and Fieldmaster. Passengers wont only benefit from greater leg room, but will also enjoy the more reclined rake of the seat back. Time required: The whole job took no more than 2 hours. Kit required: Small Phillips screwdriver / Security Torx socket / Smaller standard Torx socket / Rachet and extension bar Step 1 - Remove caged bulkhead from...
I ordered a camp table but it didn't arrive with my Grenadier (like many!) However, my old Waeco 35 fridge has died and I am looking to buy another portable fridge/freezer (bigger) that would fit in the back of the Grenadier. Therefore, I need to know how much the attached folded-up camp table protudes from the rear door. I think I read that it's approx 50mm. Can someone with a camp table measure this for me. many thanks
Thread 'Sound Deadening'
I added some sound deadening (Stage 1 only) to my Diesel Trialmaster. So far it "seems" quieter, but that could just be my brain trying to compensate for all the effort it took to get this done. Road noise seems to be not as sharp and a bit more dulled, I definitely hear the turbo whine a bit more than I used to as thats the most high pitched thing I hear now. Went to our local tip to weigh myself before and after, and it's added 30 to 40kg - unfortunately that's as accurate as I could get...
someone postet this auction of an accident Grenadier on FB. I wonder where our 8 airbags are???!!! They probably don't all deploy in a frontal collision, but I thought there were airbags in the A-pillar. I've always wondered why the A-pillar trim is made of hard plastic and doesn't have any mention of an airbag...
Thread 'KAON in Australia to develop INEOS products in 2024'
For Australian owners, KAON is coming back on board in 2024 to develop products for the INEOS. They have been No, then Yes, then No (after the new Prado was announced) and now Yes again. Updated via Ben Neville from Aussie FB page. They will develop a rear roof shelf, side molle panels and a cargo barrier.
Hello all - would someone please post a few photos of the NAS rear seats. I am ordering seat covers from Tougher and need to verify two things - 1-Is the center headrest large or small and 2-how many tie down points are on the rear seats? Thank you. @Tatum
Hi all. Just asked the question of the company and they quoted straight away. I've heard they are good, but haven't seen any fitted to a grenadier or a photo. Anyone seen them? Pedro
Sorry if this has already been discussed... I could not find it. Specifically interested in the middle part, that says Grenadier, of the overhead switch panel ... before I start pulling it all apart, has anyone already done it?
Does anyone know how to remove the large Ineos badge from the dashboard (this is the badge that replaces the digital compass and sits between the dash fresh air vents). I think this might make a good place to mount a Quad Lock phone mount. thank you
How do you remove the panelling in the footwell and at the cubby box? Or are there instructions somewhere, I can't find anything in the search. Only pictures where the panelling is already off. I would like to install additional 12V outputs and RAM mounts on the centre console.
Back
Top Bottom