Thanks , how does it attach? 3M tape or drilled and screwed?
Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please use the contact us link at the bottom of the page.
Thanks , how does it attach? 3M tape or drilled and screwed?
Hi Nocrays,Continued with the electrical build in my Grenadier.
Installed another power distribution box for the auxiliary battery. This will supply power to the inverter, fridge, air compressor as well as receiving the input from the solar panels.
Haha - Just noticed in photo I have two supply line crossed over
Next project is to mount the ARB twin compressor. Jury is out as to where to mount it. Ideally I'm looking at mounting under the vehicle with remote intakes but finding a suitable location is proving difficult.
I like the install location where the invertor was to sit (LH Rear), but I'm put off by having to purchase the different side panel. Am mucking around with design concepts to see if I can 3D print a cover to cut into the side panel to allow for the additional room of the compressor and improve airflow for cooling so it may still be doable. However I will most likely go for installing under the passenger seat as this would be an easy solution.
View attachment 7906804
great shots....
I would expect those clamps to twist under brush load. Can you swap them side-to-side, and set the arm/eye inline with the cable? Then everything is nice and tight.
