no, it was enough to give it a couple of hits with a hammer and a screwdriver
Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please use the contact us link at the bottom of the page.
no, it was enough to give it a couple of hits with a hammer and a screwdriver
Yes, this is normal. The factory splines are a touch tighter. And yes you can pry off the end cap if you want to go that route. I went path of least resistance and just cut the cover off and used my press to remove the joint.
