The Grenadier Forum

Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please use the contact us link at the bottom of the page.

Show us your crack (windshields)

If your windshield cracked (please answer honestly)

  • Diesel : NO evidence of stone chip or damage prior to crack appearing

    Votes: 21 8.4%
  • Diesel : evidence of stone chip or damage prior to crack appearing

    Votes: 32 12.7%
  • Petrol/Gas: NO evidence of stone chip or damage prior to crack appearing

    Votes: 44 17.5%
  • Petrol/Gas : evidence of stone chip or damage prior to crack appearing

    Votes: 64 25.5%
  • No crack

    Votes: 90 35.9%

  • Total voters
    251
I installed the edge protection strip today. To be honest it feels a bit me-too but given how many owners have reported cracks that propagate inwards from a chip near the unprotected edge I'll give this protection strip a crack :cool:.

Easy to install. I used less than 3 metres of the 7.9 metres (26ft) in the kit.
My MY23 has the top seal so I only needed to do the sides and bottom edge.
Preparation is important. I used a razor blade scraper to clean the glass. That lifted a surprising amount of gunk off. Then I used Isopropyl alcohol (IPA) to wipe down.
I used a heat gun to soften the molding at the bottom corners. No need for relief cuts.
I had some tape strips ready but didn't use them.
I started at the top left corner and finished at the opposite corner. I used a plastic trim tool to go past the RAI where there is less access to press your fingers onto the molding.

A 30 minute job including preparation.

Amazon USA
I am a copy-cat too, and I know @Clark Kent was not the first, and I apologize to the first poster of this solution, but I did the same today.

20250919_173457.jpg
20250919_174638.jpg


Did cost me about 50€, because I didn't find it in Europe and it came from the USA (transport costs + 21% VAT).
 
Did the same and had the same costs (in Germany).
Hope it helps, but it also looks good and that is enough reason to install it.
The seal is more than sufficient for 2 cars.
 
Last edited:
Did cost me about 50€, because I didn't find it in Europe and it came from the USA (transport costs + 21% VAT).
What & where exactly did you buy? I found the originally recommended product on Amazon, bt they would not ship to Germany...
 
What & where exactly did you buy? I found the originally recommended product on Amazon, bt they would not ship to Germany...
You can buy it at Amazon.com in the USA. They charge you and deliver as if bought at their german shop. Takes about 1-2 weeks.
Search for: tintvent rubber edge trim
 

Attachments

  • IMG_4604.png
    IMG_4604.png
    1 MB · Views: 9
Last edited:
Back
Top Bottom