Ideas for added 12v plug in dash area

[Motorradmark]

Have a new to me '24 Trialmaster.
Looking to add some needed 12v ports in the dash area.
Has anyone done and can you share pics for ideas?
Looking at either trans tunnel or lower sides of center console-close to int- prewires.
Also, can the side panels of the console come off-

Pls post pics for ideas.

 

[LabRat]

Wanted to do the same, but couldn't figure out how to get that panel off. I ended up mounting it on the panel below it on both sides.

 

[TheDocAUS]

There is thread on this recently. I am trying to find the link.

EDIT

STEDI option

Lightforce panel (RHD car)

Euro Flo option

USB Power supply mounting solutions | Euro Flo Australia

Need more power..?? This ones for you then This adaptor takes the https://www.switchboss.com.au/collections/usb-chargers/products/type-c-usb-qc-usb-charger

www.euroflo.com.au

Threads:

Thread 'USB Socket for Passenger'

Jan 28, 2026

As this is still ongoing I thought I should start it's own thread and not clog up the "What did you do with your Grenadier today?" thread with updates
https://www.theineosforum.com/threa...your-grenadier-today.12411127/post-1333379389

I got the idea from something that Pedro has done. The usb socket seemed just the thing i was looking for
https://www.theineosforum.com/threa...your-grenadier-today.12411127/post-1333378146
Switch Boss - USB charger

---

Prototype_1

Rainy wet and humid Australia day, so....
First...

• Greg
• passenger usb
• Replies: 14
• Forum: The Fettling Shop

• 
• 

 

[TheDocAUS]

Yes the side panels of the console can come off.

 

[Guvnor]

I found a much neater solution that did require a bit more work. Worst part was trying to establish if there was sufficient free & clear space behind without ruining anything….. there is.

I did take install pics but can’t find them at the moment so will update later.

 

[Fishnerd]

There is also also space on passenger side grab handle. Out of the way and not very obvious.

 

[Tenac]

There is also also space on passenger side grab handle. Out of the way and not very obvious.

This location I was eyeing, can you provide guidance on panel removal to get to this space. I don't have access to the drawings at this time.

 

[DVA Mechanics]

The console side panels do come off — they're held on with push clips. Tip: use a trim removal tool and start from the bottom edge, they pop off without too much drama. Just make sure whatever you tap into is on the accessory circuit (switched with ignition) and not constant 12V, unless you want your ports live when the truck is parked.

 

[Brad@SuperiorCO]

I ran power from the back seat to keep the dash area clean of cables.

Facebook link​