DIY - Rear Drawer system build - $150 - One sheet of plywood - 1"X8" 12 foot and 1"X6" 12 foot.

[hightechcoonass]

I built this today.
41" wide X 32" deep (sides and back are 1" x 8" pine boards.)
Drawers built with 1" X 6 " pine boards and plywood drop off 16" X 19" (bottom)
(Carpet was left over from my 4Runner drawer build, and oak drawer fronts we re-purposed from my 4Runner drawers )

linky to the pic

 

[chrsbe]

.... the image is not loading

 

[Voader - Oudersopzwier]

I built this today.
41" wide X 32" deep (sides and back are 1" x 8" pine boards.)
Drawers built with 1" X 6 " pine boards and plywood drop off 16" X 19" (bottom)
(Carpet was left over from my 4Runner drawer build, and oak drawer fronts we re-purposed from my 4Runner drawers )

linky to the pic

Nice done.

 

[Krabby]

(rest of world scurrying about trying to figure out what the hell size 16"x19" is)

 

[Logsplitter]

(rest of world scurrying about trying to figure out what the hell size 16"x19" is)

You’ll totally confuse everyone if you add in 7/64”

 

[hightechcoonass]

Ah!..... 4 pieces of 16" x 19" dropoff - to make the bottoms for the 2 drawers. drawers are 19" X 32" (I also covered the inside of the drawers with carpet (no rattles!)

BTW I did not use sliders... (I did the from my last 5 drawers systems ( Tundra, Tacoma, FJ, Bronco, and 4Runner). Whenever I was on an upper incline, they would always slide open and were difficult to close.