- Local time
- 10:23 PM
- Joined
- May 19, 2022
- Messages
- 1,908
- Reaction score
- 3,646
After installing a 12V Deutsch DT socket (from Australia!) in the boot a few weeks ago, I was able to complete the installation of 2 more sockets in the right front footwell today. However, I didn't use the right outer trim like @Jean Mercier , but went into the centre tunnel trim.
One socket takes the standard 12V plug, the other 2 different USB plugs.
If you want to do this too, please note that the installation space is very limited. Have a look at the pictures. But the sockets just about fit in these places.
I installed Deutsch connectors under the glove compartment and under the right side panel, so that I can disconnect the cable if necessary and also operate another device with a Deutsch DT plug in the right front footwell.
In this context, I would like to point out a possible connection from the footwell through the bulkhead into the engine compartment. For example, a cable of a radio antenna could be pulled through.
One socket takes the standard 12V plug, the other 2 different USB plugs.
If you want to do this too, please note that the installation space is very limited. Have a look at the pictures. But the sockets just about fit in these places.
I installed Deutsch connectors under the glove compartment and under the right side panel, so that I can disconnect the cable if necessary and also operate another device with a Deutsch DT plug in the right front footwell.
In this context, I would like to point out a possible connection from the footwell through the bulkhead into the engine compartment. For example, a cable of a radio antenna could be pulled through.