Tom109
Grenadier Owner
And if the standard rub strip also collects debris?I’d be curious to see what that looks like without the plastic trim covering the utility strip.
And if the standard rub strip also collects debris?I’d be curious to see what that looks like without the plastic trim covering the utility strip.
That gap is going to collect a massive amount of road dust/grit/debris that will slowly filter down and lodge behind the plastic belt.Something Ineos could look at - the edges of the utilty belt sit away from the body side - leaves a gap for debris, in my case fine conifer seeds, to drop into:
View attachment 7817807
I think that's what's already happening with mine.That gap is going to collect a massive amount of road dust/grit/debris that will slowly filter down and lodge behind the plastic belt.
Yes, I think it's more of a design issue rather than bad installation.I think that is poor fit & finish - it should be a snug fit.
I think it's to do with the double steps they've stamped into the doors:I assume the belt is not loose or has something wedged behind it making it sit proud?
I think I might have found a justification for one of these:Can you see if there is open space behind the gaps to allow for spraying it out? And if so, will the debris get caught inside the body or run out freely To the ground and not accumulat?
Yes, I guess it could but then becomes a maintenance nightmare.This may be a ridiculous question, but could that crack be caulked with some sort of marine sealant/caulk (Sample)? Would have to be done and cleaned very carefully, I know.
And I'd promised the Mrs I wouldn't be taking any more bits apart for a while...I’d be curious to see what that looks like without the plastic trim covering the utility strip.
Thanks for your help. However, it is not quite what i am looking for. I am looking for a bracket which will span between the grab rails and the utility belt. The L Track fittings you mention will be a part of that but not the whole solution.@Andrew Kilby I hope I understood right and you are looking for fitting for the belt?
Here‘s a link to a german online shop.
Fittinge
Wir haben eine Vielzahl unterschiedlicher Fittinge im Sortiment. Vom Single Stud Fitting über Doppel-Endbeschläge bis hin zu massiven Triple Stud Fittingen und Quattro-Stud-Fitting mit denen sich sehr schwere Lasten sichern lassen. Der Endbeschlag wird als Verbindungstück zwischen der...www.airlineschienen-shop.de
Black sheep make a molle panel that does that. And expedition HQ in Qld Australia are also making somethingThanks for your help. However, it is not quite what i am looking for. I am looking for a bracket which will span between the grab rails and the utility belt. The L Track fittings you mention will be a part of that but not the whole solution.
Thanks again.
I was directly involved in a discussion about these rails at the doors (I guess it was 2019 or 2020, I do not know exactly) with Ineos.I'm still a bit confused by the external utility belt.
Can anyone demonstrate how it will be used?
To me it seems that any proposed use will either, damage the paint (imagine a shovel or axe mounted on the side body), and/or prevent the doors from being opened (imagine maxxtrax or fishing rods that are longer than the width of the door mounted on a door).
I'm also struggling to imagine more than two or three possible applications.
Is anyone else a little confused too - or am I just being daft.
I'd love to see some images of a utility belt being 'utilised', or even just some ideas/plans.
Thanks in advance, Guardsmen.
Henry
Australia
Good points, although I must admit that I also ordered the rails.I was directly involved in a discussion about these rails at the doors
I was directly involved in a discussion about these rails at the doors (I guess it was 2019 or 2020, I do not know exactly) with Ineos.
I simply choose to not install anything that will increase the width of the vehicle, or present more opportunities for trail damage. So no external rails for me.Good points, although I must admit that I also ordered the rails.
I’ve gone for the utility rails as I thought it was a good idea at the time. No idea what I will use them for. I’m waiting for some inspiration from the forumI simply choose to not install anything that will increase the width of the vehicle, or present more opportunities for trail damage. So no external rails for me.
Hi Logsplitter, I ordered them too because they look so damm good on the Grenadier. Hoping to find good use for them too. Perhaps strapping a surfboard to the side of my vehicle. DaBullI’ve gone for the utility rails as I thought it was a good idea at the time. No idea what I will use them for. I’m waiting for some inspiration from the forum
I was directly involved in a discussion about these rails at the doors (I guess it was 2019 or 2020, I do not know exactly) with Ineos.
My statement was: "If someone would consider that as useful, I would have seen it once in the 15 years I'm active in the 4x4 community on some occasion, at fairs, while traveling or any other event. Someone would have mounted such rails, which are so common and well known and which you often find (but not on side doors). If anyone would have seen any sense in that. But I have never seen a single car with rails on the doors.
When you go camping with a car of that size the front doors are the ones which are opened and closed many times to get stuff out and in the car. It makes no sense to attach something there, while stationary. While driving it is not legal to attach things there on public roads in many countries. While on tracks or doing serious offroading I consider the rails just as collectors of dirt, branches (which lead to scratches), etc.
In case you're standing inclined on a slope having load attached to the doors, that will make them not managable. If you ever needed to open a side door (especially these heavy and ultra-robust doors of the IG) while standing inclined on a slope, you know how heavy and difficult it will become to open the door or to hold it open while you crawl out (Attention: getting hit or squeezed by such a heavy door can end up in a very bad experience). If you put additional weight on it, lets say a 6 kg fluid container...have fun opening the door and trying that it not crashes back into into the car (or you)."
I would be interested if anybody who considers these rails as useful has mounted such rails on his 4x4s in the past? If not, why are these rails are so welcome now? It doesn't take much of a genius to develop such an idea on my own. Especialy for people who tend to modify an optimze their 4x4. However, I never came across this, not while camping not while driving a trophy.
These rails just make the production more complex and expensive, while the usefullnes is in question. If it would have been clear to everyone what these are for, we wouldn't see some discussions about these rails here. I think it will end up like many other camping stuff. You go into the shop, buy this and that, all that fancy stuff but over time, with increasing experience, you filter out what is essential, what is practical and what was just a waste of time and money.
These rails are the pure idea of someone who like the car to look like a All-Time-Ready-Trophy car without any experience in camping, as this person prefers to sleep in his own hotel. However, my thoughts on this, of course, had no weight, as I'm not the sponsor of the Grenadier and the guy seems to be right, as these rails seem to attract a lot of people.
Actually I read the German Camel Trophy book by Nick Dimbleby, Andreas Berger and Volker Lapp which covers the complete Camel Trophy history very deep in detail. All the cars and their equipment are shown and discussed. No door rails... I know Volker personally, I'll ask him what he thinks about the rails
That is in deed an absolut valid reason. I find myself doing such things (like mountig auxiliary lights right above the bonnet), because it looks good. And I swear about it on a regular basis.I ordered them too because they look so damm good on the Grenadier.