I’m looking for someone to sanity-check my wiring plan.
My Quartermaster does NOT have the high-load auxiliary switch panel. I installed the Ineos cross-bar light bar (given to me), which needs a 25-amp circuit. My idea is to use Aux Switch 1 (rated for 10 amps) only to trigger a 30-amp relay, and then run a dedicated power feed to the relay with a 25-amp fuse for the actual light bar power. Does this wiring approach make sense? Not sure how I run the power to the rack yet, that I will figure out later. Appreciate any thoughts on this!
My Quartermaster does NOT have the high-load auxiliary switch panel. I installed the Ineos cross-bar light bar (given to me), which needs a 25-amp circuit. My idea is to use Aux Switch 1 (rated for 10 amps) only to trigger a 30-amp relay, and then run a dedicated power feed to the relay with a 25-amp fuse for the actual light bar power. Does this wiring approach make sense? Not sure how I run the power to the rack yet, that I will figure out later. Appreciate any thoughts on this!
