What did you do with your Grenadier today?

[spyder6255]

Katzkins interior and the rear spoiler color matched all done through MileOne INEOS Grenadier...
3141 Automobile Blvd. Silver Spring, MD 20904

Worked with the Sales Manager named Gino and the process was painless...recommend.

Thanks , how does it attach? 3M tape or drilled and screwed?

 

[Steve.B]

Continued with the electrical build in my Grenadier.

Installed another power distribution box for the auxiliary battery. This will supply power to the inverter, fridge, air compressor as well as receiving the input from the solar panels.

Haha - Just noticed in photo I have two supply line crossed over

Next project is to mount the ARB twin compressor. Jury is out as to where to mount it. Ideally I'm looking at mounting under the vehicle with remote intakes but finding a suitable location is proving difficult.

I like the install location where the invertor was to sit (LH Rear), but I'm put off by having to purchase the different side panel. Am mucking around with design concepts to see if I can 3D print a cover to cut into the side panel to allow for the additional room of the compressor and improve airflow for cooling so it may still be doable. However I will most likely go for installing under the passenger seat as this would be an easy solution.

View attachment 7906804

Hi Nocrays,

If you check the thread steps added to rock sliders, you will see how I mounted 2 ARB compressors under my vehicle.

 

[Itsdchz]

A bit of fun in Sacramento CA
Took pic after 4-5 others had already left

 

[spyder6255]

A bit of fun in Sacramento CA
Took pic after 4-5 others had already left
View attachment 7906945
View attachment 7906946View attachment 7906947

great shots....

 

[Tom109]

As an added bonus, installed branch guards
View attachment 7906323View attachment 7906324View attachment 7906325View attachment 7906326View attachment 7906327View attachment 7906328View attachment 7906329

I would expect those clamps to twist under brush load. Can you swap them side-to-side, and set the arm/eye inline with the cable? Then everything is nice and tight.

Also swap the turnbuckle up to the rack for a cleaner look?

 

[bazooka tooth]

Out and about with the littles in Jefferson National Forest.

 

[AngusMacG]

Lunch stop at the Sagamore Bridge.

 

[spyder6255]

finally got the console swapped out.. great work by the folks at grenadier usa!!!!

 

[linksK9rig]

Took the family out in the Grenadier to Myrtle Beach this past weekend. Family had a blast. I got many compliments on the Grennie along the way, it’s also a G Wagon and Jeep magnet, once I'm back to it they're parked right next to it. Had fun driving it and no issues to report on this somewhat long trip!

 

[spyder6255]

Took the family out in the Grenadier to Myrtle Beach this past weekend. Family had a blast. I got many compliments on the Grennie along the way, it’s also a G Wagon and Jeep magnet, once I'm back to it they're parked right next to it. Had fun driving it and no issues to report on this somewhat long trip! View attachment 7907037View attachment 7907038View attachment 7907039View attachment 7907041View attachment 7907040View attachment 7907042

crazy how much better the IG is than the G-wagon

 

[c00kedg00se]

Team Prancing Camel!!! Thanks again to @Brandtnm !!!