What did you do with your Grenadier today?

[Mike24Ineos]

I removed my front and rear skid plates. I am having them powder coated matte black on Monday. A local shop said 24 hour turn around.

 

[bigleonski]

Well I finally joined the very exclusive (not) cracked windscreen club yesterday.
Small chip in the lower centre (still a good 10cm from the edge) yesterday on the highway.
In any other vehicle I doubt it would have even been a chip - sloped screen the stone probably would’ve skipped over the top.
This morning first thing we went for an early morning drive to walk along the river, got back and there’s a 50cm split right across the screen. Didn’t even get time to have it repaired.
Ah well, apparently that’s part of the Ineos character.


Gotta love the timing though. One free windscreen a year, and my car insurance only rolled over last month. Could have happened in Feb.

 

[Clark Kent]

Well I finally joined the very exclusive (not) cracked windscreen club yesterday.
Small chip in the lower centre (still a good 10cm from the edge) yesterday on the highway.
In any other vehicle I doubt it would have even been a chip - sloped screen the stone probably would’ve skipped over the top.
This morning first thing we went for an early morning drive to walk along the river, got back and there’s a 50cm split right across the screen. Didn’t even get time to have it repaired.
Ah well, apparently that’s part of the Ineos character.


Gotta love the timing though. One free windscreen a year, and my car insurance only rolled over last month. Could have happened in Feb.

Bugger...

Keep it. In some circles a split screen model is worth more.

 

[MarksGrenadier]

I have a friend who put in the GP Factor winch, said it took him 3 days. I had a shop here in Denver install mine, it was 10 hours shop time. So allow a couple of days.

I have been reading that. I may need to get some help on this one. I was installing my CA tuned arb compressor today and could not find any directions on what wires go where. Should have neen included but nothing. Its installed but there are tons of wires I do not need and when I wired the switch it did not work, I tried moving wires and broke the switch removing the wires from the post. Luckily summit racing is down the street so i have a new switch. I will wait for CA Tuned to call me and get me the proper instruction so I wire it up corretly and figure our all the spare wires. Chime in if you have an answer on this.

Now I have a check engine light on and the cruise control does not appear to work. Not sure if its related to my crappy wiring but i'm bummed as the dealer is 2 hours away.