the place to upload your MOAB images for the community
The Grenadier Forum

Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please contact admin@theineosforum.com for a commercial account.

EXT 5 location

FareGame

Grenadier Owner
Local time
8:51 PM
Joined
Apr 8, 2025
Messages
5
Location
New Zealand
Does anyone have a photo in a right hand drive vehicle of where the ext 5 wires are - we found ext 1 (verified with meter) and according to everything I’ve read ext 5 is meant to be near it but we cannot see it
 
Does anyone have a photo in a right hand drive vehicle of where the ext 5 wires are - we found ext 1 (verified with meter) and according to everything I’ve read ext 5 is meant to be near it but we cannot see it
Look for plastic tape on the vinyl tape, that is attaching the wire ends to the loom. I am finding the photo link now.
 
Rok Dr Guide reveals all.
1747091576460.png

Number 10 below (for RHD car). Right near the airbox. Look for the plastic tape on the vinyl tape around the loom. Often wire ends are under the loom and not immediately obvious. EXT 1 and EXT 5 are often taped together (but sometimes they are not). EXT5 comes with the Optional High Load Auxiliary Switch Panel option. If you have the EXT5 switch those wire ends should be there, just expand the search out from the EXT1 wire ends. Some owners found then after removing the airbox. I had trouble finding mine even though I knew the location. INEOS hide them well!
1747091641430.png

All wire ends summerised in a Table here.
 
Last edited:
Yeah that’s were we looked - the dealer extended one set which turned out to be ext1 - think they did remove the air box to do that too - ineos should just put a DT/P plug on them be so much easier

Great book on info too - have it saved with me

Have to have door buttons replaced so will get them to look again - I want the light bar on switch 5 for power not via battery remotes - using the steady loom it was just a simple matter of swapping the aux lights plug around in loom and I have high functioning normal - light bar and aux off the factory roof button (high trigger) but if can power from 5 can then have just the aux lights going - nicer for highway driving
 
Back
Top Bottom