REMOVAL OF THE HUMP ON THE DRIVERS SIDE RIGHT HAND DRIVE ONLY.

[ROKY]

After putting about 4,000 km on the insert, I have to agree it’s not a complete solution, just an improvement, which is disappointing. A full replacement floor panel is the way to go. If it were made from thicker rubber, it could potentially serve as both a replacement panel and a functional floor mat. But… maybe this is a long way off.

 

[Harry]

I have just installed the GrenX left for “thing”. It works!

Cheers,
Harry.

 

[Tom Ireland]

I was annoyed with the hump, especially if I was wearing chainsaw boots with thick soles.
I had a look and there is about an inch of foam stuck under the lining.
I went at it with a knife and I reckon I gained around 2 cm which has made the world of difference.
It is a bit butchered though
Is it possible to buy the gren x thing in Europe?