3D print Front Seat Back Recline Lever 2025-08-02

[Brad@SuperiorCO]

Brad@SuperiorCO submitted a new resource:

Front Seat Back Recline Lever - STL file for new lever to change out Riccarro lever, RHD.

Thanks to Ladislav Cocher for sharing his design for a new seat back recline lever. It is so much better than the Riccarro. After printing it took 5 minutes to lift the old one off and install the new one.
Ladislav recommendations that I followed

1. ASA375
2. Minimum 5 perimeters
3. 40% infill
4. Need to mirror for the LHD drivers seat.
5. I also sanded the sharp edges off, and painted with a grey to match the seat.

Read more about this resource...

 

[parb]

How hard is it to get the stock lever off?
I just finished printing mine and am about to take off the stock lever but want to make sure I don't destroy something

 

[Brad@SuperiorCO]

How hard is it to get the stock lever off?
I just finished printing mine and am about to take off the stock lever but want to make sure I don't destroy something

It just popped off with the pry bar, just a plastic friction fit. Easy.

 

[parb]

Thanks!