Register a free account today to become a member! Once signed in, you'll be able to contribute to the community by adding your own topics, posts, and connect with other members through your own private inbox! INEOS Agents, Dealers or Commercial vendors please use the contact us link at the bottom of the page.
What’s the underside like? Can you give a precise measurement of the recess?
It always seems to be the rears that do this...
Difficult to tell, I got the impression that what had come off was an enamel very thin cover to the section that fits into the bonnet slot. So this thin cover is only held on by some not so good double sided sticky tape, not 3M quality, and positioned by two very small 1mm pins. There is no recess for this cover as such just a 1mm rim on the cover to hold it in place. Unfortunately I had gorilla glued it back before I picked up your thread otherwise I could have investigated further.
Makes you wonder what else is held together using the same technique
I have never used a pressure washer on the painted surface of a car. Just be careful man! Those are for the undercarriage only. I know it is tempting to shoot that bad boy at the body, but don’t!
VHB is used to hold on all sorts of pieces on lots of vehicles in the past 20-25 years...Makes you wonder what else is held together using the same technique
Road salt,You washed your grenadierwhy???
Non-helpful comment... It's on my list
Check for me and post back
