Grenadier Badges

[Sam]

Hadn't seen that, thanks...

 

[Beormund]

I didn't realise that there is a badge on the front of the Grenadier underneath the front windscreen on the left side.

A close photo says Fieldmaster and I suspect a Trialmaster but what will a standard wagon say?


View attachment 7792160View attachment 7792161

First time I've seen this. Would have preferred it if the A in GRENADIER was red and the background silver rather than black. Too many rectangles at the moment.

 

[DCPU]

 

[Halliwell Jones Chester]

That 550NM is now down at 1250RPM

 

[Davman]

That Payload ain’t 1000kg either.

 

[grenadierboy]

I think INEOS should be giving the first model a specific designation badge for the car; say, a numeric model number; e.g. G1

Then, as new models or variants are subsequently released they get a different designation like G2, G3 and so forth.

Thoughts?

 

[Cheshire cat]

Personally not too keen on the badge located front / centre of bonnet / hood.

 

[DaveB]

Personally not too keen on the badge located front / centre of bonnet / hood.

That's where it is on most vehicles?

 

[Tazzieman]

Personally not too keen on the badge located front / centre of bonnet / hood.

Find another!
I just bought my wife a prancing moose for her new EV.
It would look pretty good on a Grenadier. I should steal it!

 

[Cheshire cat]

That's where it is on most vehicles?

And it looks good on most vehicles but not so sure it looks right on this vehicle. Just putting it out there

 

[DaveB]

And it looks good on most vehicles but not so sure it looks right on this vehicle. Just putting it out there

Maybe instead of the spirit of ecstasy we need to get a Grenadier to stand up there

 

[DCPU]

Personally not too keen on the badge located front / centre of bonnet / hood.

You need to try and get hold of an early prototype bonnet - no stamped recess or two holes in them.

 

[Krabby]

Are we confident that the product hood (bonnet) will have an indent/holes? Or might to badge just use adhesive?

 

[DCPU]

Well everything is subject to change.. but it's clear in this photo:

 

[ECrider]

Are we confident that the product hood (bonnet) will have an indent/holes? Or might to badge just use adhesive?

i'd quite like your avatar as a bonnet badge

 

[DaveB]

i'd quite like your avatar as a bonnet badge

I have to admit the Ineos badge looks a bit crap

 

[emax]

I'd glue a Rubber Duck there.

Kristofferson would appreciate it.

 

[Tazzieman]

I'd glue a Rubber Duck there.

Kristofferson would appreciate it.

How about

Pardon our interruption...

 

[ECrider]

or a flying butt plug for those cyclists who refuse to cycle single file when they really should

 

[DaveB]

How about

Pardon our interruption...

I might encapsulate my fathers medals and mount them on the front
I think he would like that