Green mystery button?

[kevrenmorland]

I just purchased my enosio used.I have been trying to figure out all of the aftermarket things added.I have figured out everything else , except for this green button. You can press it in, and then it springs back. I have tried pressing it when the truck is off and see and hear nothing. I have also tried it when the car is on.What is on the left side of the steering wheel. Is everybody seeing this before? I was hoping somebody has seen this, before I have to start bigging into the dash and following the wires period. Thank you.

 

[LC0013]

Eco Mode.

 

[HeavyFoot]

See if your aux light turn on. If not, pop the panel and trace the wire. Possible that they had it connected to something else that they took off when they traded the car in.

 

[Clark Kent]

Wouldn't be the first time...

 

[Tazzieman]

My enosio such button hasno

 

[GN4HIR]

STOP PUSHING IT.. Every time you do, my garage door opens!

But seriously.. it may be left over from some lights. What is unusual is you describe it as a momentary switch. Perhaps it was to change the mode / color of some aftermarket lights.

 

[C-Mack]

Looks like you are the one and only owner who has the DIY “Service Reset” button installed.

 

[theox]

Was the last owner a Commander in the Royal Navy? Was his other car an Aston?

 

[Tazzieman]

Was the last owner a Commander in the Royal Navy? Was his other car an Aston?
View attachment 7925166

The original JB drove Bentleys.

 

[CRH]

Are you able to contact previous owner or do you have the privacy rules we now have in UK that doesn't give previous ownership on the documents?

 

[Happyoldgit]

Just trace the wires - as has been suggested.

 

[Ovrland Bill]

In the finest tradition of ever present “mystery buttons” in airplane cockpits.

 

[CRH]

Self destruct

 

[Eric]

I'm afraid the only solution is to trace and check the wiring, because if it was down to some " equipment " that has now been removed you need to check it was removed properly and you don't have " live" wires dangling down somewhere.

 

[Tazzieman]

I'm afraid the only solution is to trace and check the wiring, because if it was down to some " equipment " that has now been removed you need to check it was removed properly and you don't have " live" wires dangling down somewhere.

Pull the button out, bare the wires, turn ignition on and touch the wires together. Find which fuse has blown and correlate with the source of smoke.
That would work