3D print Button Pusher - 3d printed version 1

[derek_zoolander]

derek_zoolander submitted a new resource:

Button Pusher - 3d printed version - 3d printed button pusher!

Hey all! Happened on a second hand 3d printer and figured i'd fab up something for the grenny. New to all this so no clue what I'm doing but it works in my car.

I designed and printed a button pusher b.c it seemed like a fun project and wasnt something I'd ever spend north of $50 on. Advantage is I am able to utilize the factory screw for it and it recesses into the factory screw hole (bottom left on a LHD Grenny).

Feel free to edit/remix, whatever but if you do, share the design...

Read more about this resource...

 

[MileHigh]

I printed some but I don’t think they are working? To make it so that you don’t have to press the button every time, this should hold the bottom in the down position, right? When I printed it, it mounted find, but doesn’t seem to depress the button very far? Not enough to change the state or all the way down?? Am I understanding it right?

 

[derek_zoolander]

For me, I push the button with my finger till it engages then rotate over to hold the switch down. Mine holds the button fully depressed or close to it.

 

[derek_zoolander]

@MileHigh, here is a photo of mine. Is yours fully seated and recessed into the screw hole? If its not, it may not depress the button enough.