3D print Another Stop-Start Lever 2025-11-14

[MileHigh]

MileHigh submitted a new resource:

Another Stop-Start Lever - A stop-start STL to keep the button depressed

I don't know why, but the other STL here didn't slice well in PRusaSlicer the round part was not continuous around the circumference, it would put a seam on it? Tried it set on Prusa Mini and Mk4, and wanted to do the same.

I re-did the part in TinkerCAD and after optimized the size for standard PrusasSlicer setting for a Mk4. Printed it off in PETG and it seems good. I tried to add some adjustability in it. I didn't figure it out until later, but the upper right screw is a lot longer...

Read more about this resource...