Front Plate

Stonewall554 · Mar 22, 2024

Hi y'all, How is everyone going about putting on the front license plate? I didnt go with the winch (although now I kinda wish I had) so im assuming that would be the spot to add a bracket for the front plate (universal im guessing since I doubt they have a Grenadier specific one). Just curious what everyone is doing.

angstorms · Mar 23, 2024

I am, my wife was pulled over outside of San Angelo for missing the front plate on my Audi, we given warning since I had the front plate in the car, told to mount it asap. Ended getting self tapping screws at Home Depot latter that day to mount it. We were on our way to Durango. so had few more mile to go in west Texas. Down here in Austin they do not care if it on or off.

sayntzero · Mar 24, 2024

I was wanting to ask the same thing. Just picked mine up and waiting for the plates. I did opt for the winch, and looking at the swing out cover, it has small notches for screws, but they seem shallow. If anybody has suggestions on this, I am open. I'll post what I do here.

Side note, I haven't had a front license plate on my Tacoma in Texas for over ten years. I've only got pulled over when I am coming back from out of state on the Colorado side. They sniff for weed, and then give me a warning.

Jimbo · Mar 24, 2024

Stonewall554 said:
Hi y'all, How is everyone going about putting on the front license plate? I didnt go with the winch (although now I kinda wish I had) so im assuming that would be the spot to add a bracket for the front plate (universal im guessing since I doubt they have a Grenadier specific one). Just curious what everyone is doing.

When I went to pick up my registration at Sewell they installed a front bracket when they put the plates on. I do not have a winch either.

Rupert · Mar 26, 2024

Once again, I was shorted by Sewell.....no front plate bracket. But I'm glad I didn't get one!! Rebel without a Cause.

Gillis · May 1, 2024

There was one installed on mine when I picked it up.
Additionally, I got the towing package with the front receiver and the bracket they provided for the license plate flips up and out of the way of the receiver. It is kind of slick!

Stu_Barnes · 2024-05-15T14:30:34+0100

Im in the same boat, I queried INEOS and found out that this is a dealer supplied item and they have been paid by INEOS to install it.

grnamin · 2024-05-15T14:37:46+0100

sayntzero said:
I was wanting to ask the same thing. Just picked mine up and waiting for the plates. I did opt for the winch, and looking at the swing out cover, it has small notches for screws, but they seem shallow. If anybody has suggestions on this, I am open. I'll post what I do here.

Side note, I haven't had a front license plate on my Tacoma in Texas for over ten years. I've only got pulled over when I am coming back from out of state on the Colorado side. They sniff for weed, and then give me a warning.

I drilled through the flip-up license plate holder and used washers, nuts and bolts to secure the plate.

Search

Search

Front Plate

Navigation

About

Share this group

Stonewall554

angstorms

sayntzero

Jimbo

Rupert

#4082

Gillis

Stu_Barnes

grnamin