I am looking for the dimensions below if anyone has it please. L-track width, pitch and hole diameter.
They are a number of different aftermarket sizes and pitches, so just want o to make sure I buy the correct one.
Hi where can I get a grabrail to fit right- hand side front "A"- post
My friend has a bad knee and does not want to keep using the steering wheel to assist getting in
Thanks
Brian
Are the drip rails perfectly straight, and parallel like the Gwagon? and what is the minimum clearance height? Say if one were to lay a straight edge across the roof and measure down to the inner top of the drip rail.
If anyone has that info, that would be greeeeeeat. Thanks.
Good morning everybody,
does anybody know how big is the hole spacing of the lashing rail in the car boot?
There is a international size of 1'' (= 25,4 cm) and a size for the EU-market which is exactly 25 cm.
Thank you for your answers.
Greetings
Roland
Does anyone know if the Interior Utility Rail Belt is standard size and accepts normal SS Anchors? I already had some and didn't want to spend $60 to purchase from Ineos. It's just a single stud fitting SS-Anchor
I already saw the AluCab brackets, and they are not what I'm after. Something smaller to mount a crossbar of my choice to the round 'grab bars' on both sides. Need low profile. Searching.........
Are the L-track rails on the exterior and in the interior cargo area magnetic? I assume that they are aluminium extrusions, or maybe non-magnetic stainless steel?
At Christmas it was very wet in Germany and I drove about 1500 km in the rain.
When I arrived home, I wanted to install my DIY rubber trunk mat and unscrewed the airline rails. To my surprise, the screws on the underside were wet. How does water get in from below?
It is noticeable that both...
I was thinking about the Jeep use of ducks left for other owners. For the IG, I think that the cargo rail on the side would be a perfect way to acknowledge someone’s IG. Make something compatible with that attachment point. My idea is that you take the standard attachement point, and then...
Yesterday, I made my GoPro camera mount for the utility rail. I used the fittings I have shown here:
https://www.theineosforum.com/threads/airline-rails-track.12411220/post-1333208696
The photographs are partially a bit unsharp as it was already getting dark when I mounted them.
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.